Table of Contents
Advertisement
Quick Links
K&A Manufacturing
6703 Zinser Street
Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Version Dated: 7/11/16
NewHeights™ Series 4 NZP
Levante Crank Height
Adjustable Conference Table
Read all the instructions before beginning.
Instruction # 53440
Hardware Pack # 53433
Page1 OF 7
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for RightAngle NewHeights 4 NZP Series
Summary of Contents for RightAngle NewHeights 4 NZP Series
- Page 1 K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com Version Dated: 7/11/16 NewHeights™ Series 4 NZP Levante Crank Height Adjustable Conference Table Read all the instructions before beginning. Instruction # 53440 Hardware Pack # 53433 Page1 OF 7...
- Page 2 Tools Required for Assembly: Power Driver W/Adjustable Torque #2 Phillips Head Driver Bit or #2 Square Head Driver Bit K&A Manufacturing 3/16" Hex Head Driver Bit or 6703 Zinser Street Schofield, WI 54476 Allen Wrench Phone: 800.298.4351 Fax: 866.882.9475 Tape Measure www.raproducts.com Level 53638...
- Page 3 Costs incurred due to product replacement such as installation labor and transportation are not covered under this warranty. When corresponding with RightAngle™ Products, provide the model and serial numbers located on one of the leg assemblies.
- Page 4 Step 1: Lay the worksurface 1 on a protected surface with the pilot holes facing up. Align the holes in the crank bracket 17 with the pilot holes in the worksurface. Attach it with (4) wood screws 4 . Do not over-tighten the screws. K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Use a low torque setting on the power driver.
- Page 5 Step 5: Slide one end of the main drive tube 9 onto the gear drive on the gear drive assembly 6 .Place the left leg K&A Manufacturing assembly 2 (Leg A) on the worksurface 1 guiding the 6703 Zinser Street Schofield, WI 54476 other end of the main drive tube into the gear drive near the Phone: 800.298.4351 Fax: 866.882.9475...
- Page 6 Step 6: With the help of an assistant align the cross support 14 with the stickers on both leg assemblies. See below. Insert (4) socket screws 12 through the holes in the ends of the cross support and thread them into the weld nuts that are held in place by the stickers.
- Page 7 Step 8: Attach the leg assemblies 2 and 3 to the worksurface 1 with (16) wood screws 4 . Do not over-tighten the screws. Use a low torque setting on the power driver. K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 Step 9: Align the holes in the u-channel 16...
Need help?
Do you have a question about the NewHeights 4 NZP Series and is the answer not in the manual?
Questions and answers