To Change The System Programming Password; To Configure Unequipped Line Interfaces; To Configure Disconnected Extensions - BT Versatility Manual

To change the System Programming Password

The default System Programming Password (1111) can be changed to any 4-digit number.
• From the Programming Extension, press the PROGRAMME Key
• Press the Scroll Down Key ( ) until 'System programming' is displayed.
• Select 'System programming'.
• Enter the System Programming Password and select 'System'.
• Select 'Change password'.
• Select 'Change' and enter the 4-digit number you require.
• Select 'Confirm'.
Press the Hands-free Key to finish programming.

To configure unequipped Line interfaces

The system assumes that available Line interfaces have exchange lines connected to them. If a
line interface does not have an exchange line connected ensure correct system operation by
unequipping the line interface in system programming, as follows:
• From the Programming Extension, press the PROGRAMME Key
• Press the Scroll Down Key ( ) until 'System programming' is displayed.
• Select 'System programming'.
• Enter the System Programming Password and select 'Lines'.
• Press the Scroll Down Key ( ) until 'Equipped Lines' is displayed.
• Select 'Equipped lines'.
• Select the lines you wish to equip or unequip.
Unequipped lines are denoted by a ◊.
Press the Hands-free Key to finish programming.

To configure disconnected Extensions

The system assumes that all available extension interfaces have devices connected to them. If an
extension interface does not have a device connected, ensure correct system operation by
disconnecting the extension interface in system programming, as follows
• From the Programming Extension, press the PROGRAMME Key
• Press the Scroll Down Key ( ) until 'System programming' is displayed.
• Select 'System programming'.
• Enter the System Programming Password and select 'Extensions'.
• Press the Scroll Down Key ( ) until 'Extension disconnect' is displayed.
• Select 'Extension disconnect'.
• Select the Extensions you wish to connect or disconnect. Disconnected Extensions are
denoted by a ♦.
Press the Hands-free Key to finish programming.
Note: When a Featurephone is disconnected in programming, the Featurephone display will
show 'Disconnected'. However, when the handset is lifted a busy tone is heard and no options
will be displayed.
Owner's Manual
Equipped lines are denoted by a ♦.
BT Versatility
88