Inserting And Removing Devices; Inserting The I/O Module; Figure 7: Insert I/O Module (Example); Figure 8: Snap The I/O Module Into Place (Example) - WAGO 753-466 Manual

WAGO-I/O-SYSTEM 750
753-466 2 AI 4-20 mA S.E.
Pos : 63.6 /All e Seri en ( Allgemei ne Module)/Ü bers chriften/Ebene 2/Geräte einfüg en und entfer nen - Ü berschrift 2 @ 3\mod_1231768483250_21.doc x @ 25950 @ 2 @ 1
5.2

Inserting and Removing Devices

Pos : 63.7 /All e Seri en ( Allgemei ne Module)/Sicherheits- und s ons tige Hi nweis e/Ac htung/Achtung: Arbeiten an Ger äten nur s pannungsfr ei durc hführ en! @ 6\mod_1256193963573_21.doc x @ 43426 @ @ 1
Perform work on devices only if they are de-energized!
Working on energized devices can damage them. Therefore, turn off the power
supply before working on the devices.
Pos : 63.8 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/D emontieren/I/O-Modul einfüg en @ 3\mod_1231769726703_21.doc x @ 25989 @ 3 @ 1
5.2.1

Inserting the I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 7: Insert I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 8: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or to
the previous or possibly subsequent I/O module are established.
Pos : 63.9 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.5.0
Mounting 29