Table of Contents
Advertisement
Operator's Manual: Seed Titan™ 2XT Seed Tender
Section 5: TROUBLESHOOTING
In the following trouble shooting section, we have listed many of the problems, causes and solutions to
the problems which you may encounter.
If you encounter a problem that is difficult to solve, even after having read through this trouble shooting
section, please contact your authorized dealer, distributor or the factory. Before you call, please have
this Operator's Manual and the serial number from your machine ready.
Problem
Cause
Engine will not start
No fuel
Low engine oil
Cold engine
Ignition key switch off
Battery dead
Engine problem
Auger will not start
Not rotating
Hydraulic pump couplings or auger motor
connection
Flow control valve
No hydraulic oil
Hydraulic valve or motor
Electrical functions are not working properly
Battery cable or battery
Improper ground
Remote throttle doesn't work
No input power
01.2020
Solution
Fill the fuel tank
Fill the crankcase with oil
Open choke
Turn ignition key switch on
Recharge or replace battery
Refer to engine manual
Start engine and increase speed above 1400 RPM
Repair or replace
Check flow settings
Check oil level
Ensure hydraulic pump is working properly and
hydraulic reservoir is filled with oil.
Check battery cable and make sure battery is fully
charged
Check for proper grounding of electrical circuit
Check charge of battery. Recharge or replace, as
required
Check connections in the remote throttle harness.
Be sure connectors are clean and terminals are
firmly pushed together.
®
5-1
Advertisement
Table of Contents
