Attaching To Tow Vehicle - Meridian SEED TITAN 2XT Operator's Manual

Operator's Manual: Seed Titan™ 2XT Seed Tender

3.5 ATTACHING TO TOW VEHICLE

UPENDING HAZARD
Do not stand over hitch when unhooking
the trailer from the tow vehicle.
Load seed box 1 (closest to hitch) first
to keep weight on the hitch.
Unload seed box 2 first
to keep weight on the hitch.
CRUSH HAZARD
Ensure that all bystanders, especially
small children, are clear of work area.
Ensure there is enough room
and clearance to safely
back up to the tender.
1. Complete the Pre-operation Checklist.
2. Use the trailer jack to lift the hitch above
the height of the receiver on the tow vehicle
(standard hitch assembly shown).
3. Remove the retainer pin. Release or open
the receiver by pulling the locking cover
back, as shown.
4. Slowly back the tow vehicle until the hitch
and ball are aligned.
5. Lower the hitch onto the ball.
6. Raise the jack and place it in its stowed
position.
3-10
BOX 1
(closest to hitch)
Fig 21 - Box position identification
Fig 22 - Trailer jack
Fig 23 - Hitch receiver
®
BOX 2
(Rear of tender)
01.2020