Delivering Seed To Planter - Meridian SEED TITAN 2XT Operator's Manual

Operator's Manual: Seed Titan™ 2XT Seed Tender
1. Position the seed tender near the planter.
2. Shut off the engine of the tow vehicle, set
the parking brake, and remove the ignition
key before leaving the cab.
IMPORTANT:
Seed tender must be connected to
tow vehicle at all times during operation
to avoid unit from tipping backwards.
ELECTROCUTION HAZARD
Keep away from power lines.
• Be aware of your surroundings when raising
or lowering the auger tube.
• Maintain at least 20 feet between the
equipment and any electrical hazard.
• Contact with electricity can result in serious
personal injury or death.
CRUSH HAZARD
Do not move the upper auger tube
while the seed box(s) are unlatch.
3. Start the gas engine.
a. Move fuel valve lever to the ON position.
b. To start a cold engine, move choke lever
to the CLOSED position.
c. Turn the key switch to the START
position. Release the key switch when
the engine ignites.
4. Allow the engine to warm up for two or three
minutes. If the choke was closed to start
the engine, gradually open it as the engine
warms up.
3-14

3.7 DELIVERING SEED TO PLANTER

Fig 30 - Auger tube in transport position
Fig 31 - Gas engine
®
01.2020