Table of Contents
Advertisement
Operator's Manual: Seed Titan
Section 5: TROUBLESHOOTING
In the following trouble shooting section, we have listed many of the problems, causes and solutions to
the problems which you may encounter.
If you encounter a problem that is difficult to solve, even after having read through this trouble shooting
section, please contact your authorized dealer, distributor or the factory. Before you call, please have
this Operator's Manual and the serial number from your machine ready.
PROBLEM
CAUSE
Engine will not start
No fuel
Low engine oil
Cold engine
Ignition key switch off
Battery dead
Engine problem
Conveyor will not start
Not rotating
Drive pulley connection or conveyor coupling
Drive belt slipping
No hydraulic oil in reduction case
Failed centrifugal clutch
Electrical functions are not working properly
Battery cable or battery
Improper ground
Revised 02.2021
2SE/4SE Box Seed Tender
™
SOLUTION
Fill the fuel tank
Fill the crankcase with oil
Open choke
Turn ignition key switch on
Recharge or replace battery
Refer to engine manual
Start engine and increase speed above 1400 RPM
Repair or replace
Increase belt tension
Check oil level
Replace clutch
Check battery cable. Be sure battery is fully charged.
Check for proper grounding electrical circuit
continue on next page
5-1
Advertisement
Table of Contents
