Machine Break-In; Before Starting; Inspections At 1/2, 5, And 10 Hours - Meridian SEED TITAN 2XT Operator's Manual

Operator's Manual: Seed Titan™ 2XT Seed Tender
3-8

3.3 MACHINE BREAK-IN

A special break-in
developed to ensure the integrity of the seed
tender when first put into service. Follow the
Before Starting instructions and then follow the
Inspections for 1/2, 5, and 10 hour instructions
at the appropriate interval.
After completing these instructions, follow the
normal service schedule in the Maintenance and
Service sections and the engine manual.

3.3.1 Before Starting:

1. Read and follow the instructions in this
manual, and the engine manual.
2. Review and follow
Checklist before starting machine.
3. Initially check wheel bolt torque and then
again at 10, 25, and 50 miles.
Refer to Section 7.4 Bolt Torque.
4. Start the engine and check the controls. Be
sure that they function properly.

3.3.2 Inspections at 1/2, 5, and 10 Hours:

1. Check the engine.
- Fill fluids as required.
2. Check the bolted connection between the
hydraulic motor and auger.
3. Check hardware and fasteners; frame to
trailer tie-downs, all fasteners, and wheel
bolts. Tighten to their specified torque.
4. At 10 hours, change the engine oil.
- Check engine manual for the specified oil.
procedure has been
the Pre-Operation
®
01.2020