Table of Contents
Advertisement
Operator's Manual: 240 FF Basic Seed Express
Section 5: TROUBLESHOOTING
In the following trouble shooting section, we have listed many of the problems, causes and solutions to
the problems which you may encounter.
If you encounter a problem that is difficult to solve, even after having read through this trouble shooting
section, please contact your authorized dealer, distributor or the factory. Before you call, please have
this Operator's Manual and the serial number from your machine ready.
Problem
Possible Cause
Engine will not start
No fuel
Low engine oil
Cold engine
Ignition key switch off
Battery dead
Engine problem
Conveyor will not start
No power and belt not rotating
Engine to pump coupler
Belt tension
No hydraulic oil in reservoir
Hydraulic are not working properly
Hydraulic valve or pump is malfunctioning
Electrical switch not working
Battery or battery cable
Intermittent function
Improper ground
Revised 01.2022
Bulk Seed Tender
™
®
Possible Solution
Fill the fuel tank
Fill the crankcase with oil
Open choke
Turn ignition key switch on
Recharge or replace battery
Refer to engine manual
Start engine and increase speed above 1400 RPM
Repair or replace
Increase belt tension
Check oil level
Ensure hydraulic pump is working properly and
hydraulic tank is filled with oil
Check battery cable and make sure battery is fully
charged
Loose connection at the valve coil.
Check for proper grounding electrical circuit
®
5-1
Advertisement
Table of Contents
