Table of Contents
Advertisement
Operator's Manual: Seed Titan™ 2XT Seed Tender
Efficient and safe operation of this Meridian®
Bulk Seed Tender requires that each operator
reads and follows the operating instructions and
all related safety precautions identified in this
manual.
This pre-operational checklist is provided for
both personal safety and to maintain the efficient
operation of the tender. Check the following
areas each time before you operate this tender:
1. Lubricate the machine, as outlined in the
Service and Maintenance section.
2. Check the engine oil and fuel levels.
- Add, if required.
IMPORTANT:
The engine warranty is void
if the engine is run without oil.
3. Check the hydraulic oil level in the reservoir.
- Add, if required.
4. Check the hydraulic motor coupler for wear.
5. Check hardware and fasteners; seed tender
frame to trailer tie-downs, hitch bolts, trailer
hitch to trailer bolts, and all other fasteners.
Tighten to their specified torque.
6. Make sure the wheel bolt lug nuts are tight.
01.2020
3.4 PRE-OPERATION CHECKLIST
7. Check the tires and ensure that they are
inflated to their specified pressure.
8. Remove all entangled material.
9. Visually inspect the auger, auger tube, and
delivery spout for damage.
10. Test the Break-Away brake unit and the
trailer brakes.
d. Make sure the trailer brakes are operating
properly.
e. Be sure the trip wire to the break-away
switch is connected to the tow vehicle.
f.
Make sure the pin is correctly installed in
the break-away switch.
g. Press the Test button to see if the
indicator illuminates green. If the red
light illuminates, the battery charge is
low. Refer to the Break-Away System in
the Maintenance section for instructions
on charging the battery.
®
3-9
Advertisement
Table of Contents
