Table of Contents
Advertisement
Operator's Manual: Seed Titan™ 2XT Seed Tender
PERSONAL INJURY HAZARD
• Store the tender in an area away from
human activity.
• Do not permit children to play on or around
the stored machine.
• Store the unit in a dry, level area. Support
the frame with planks, if required.
3.9.1 Placing into Storage:
After the season's use or when it will not be
used for an extended period of time, the tender
should be inspected and prepared for storage.
Repair or replace any worn or damaged
components to prevent unnecessary downtime
at the beginning of the next season.
To have a long, trouble-free life, follow these
instructions:
1. Remove all seed from the hopper chutes
and inside the auger tube.
2. Inspect all moving or rotating parts and
remove any entangled material.
3. Thoroughly wash the tender to remove all
dirt, mud, debris and residue.
- Wash around and inside the hoppers ad
their chutes.
- Clean inside the auger tube.
4. Lubricate all grease fittings and bearings.
Refer to Section 4.2
Make sure that all grease cavities have
been filled with grease to remove any water
residue from the washing. This also protects
the bearing seals.
5. Inspect, clean, and lubricate the auger tube
hinge.
3-18
3.9 STORAGE
6. Inspect the condition of the auger flighting
and delivery spout. Replace or adjust, as
required.
7. Touch up paint nicks and scratches to
prevent rusting.
8. Remove the ignition key and store in a
secure place.
9. Remove the battery.
- Be sure it is fully charge, check monthly.
- Store it inside.
- Do not sit battery on a cold, concrete floor.
10. Store the machine inside if possible.
- If it must be outside, cover with a
waterproof tarp and tie down securely.
3.9.2 Removing From Storage:
When removing the tender from storage, in
preparation for work:
11. Remove the tarp, if covered.
12. Install and connect the battery.
13. Review
Checklist.
14. Review and follow the Service Intervals in
the Maintenance section.
If the machine has been stored for more than
twelve months, warm the engine by running
it for two to three minutes. Then drain the oil.
Change the oil while the oil is warm
and
follow
the
IMPORTANT:
to remove any condensation.
®
Pre-Operation
01.2020
Advertisement
Table of Contents
