Table of Contents
Advertisement
Operator's Manual: Seed Titan™ 2XT Seed Tender
Auger On/Off Switch:
This toggle switch controls the auger motor.
Note:
The switch and wiring harness
can be moved to more
convenient location.
6. Engine Circuit Protection
Tender Hoppers:
The circuit protector protects the battery
There are two hoppers, fitted with rubber boots.
charging circuit. A short circuit, or a battery
In this manual we identify their positions as:
connected with reverse polarity, will trip the
• Seed box 1 sits closest to the hitch.
circuit breaker. The green indicator inside the
• Seed box 2 sits at the rear.
circuit protector will pop out to show that the
circuit protector has switched off.
Box Lock Latches:
There are manual handles on the right-side
of the tender which pivot to turn the latches,
locking the box in place.
Insert the snap pins to lock the handles.
Hopper Lids:
These lids cover the hoppers when the tender is
not in use. When the lids are not needed, store
them upsidedown along the center of the tender.
7. Battery (12 Volt)
A 12 Volt battery supplies the power to start
Use the snap pins to keep them secure.
the gasoline engine. The battery must be
periodically recharged from an external source
to keep it fully charged.
3-6
Fig 15 - Throttle switch
8. Auger/Engine Throttle Switch
This two‑position toggle switch controls the
throttle for the engine. Move the switch to the
right to increase the engine speed and to the
left to decrease the speed.
Note: The switch can be moved to any
convenient location by relocating the
switch and wiring harness.
Fig 16 - Tender hopper and latches
Fig 17 - Hopper lid, shown in storage
®
01.2020
Advertisement
Table of Contents
