Cannot Connect The Scanner And A Computer With The Network - Fujitsu SP-1120N Operator's Manual

Cannot Connect the Scanner and a Computer with the Network

Check the following points
● Is the scanner connected to a network device (such as a switch, a hub, or a router) via a LAN cable?
(page 97)
● Is the network device (such as a switch, a hub, or a router) turned on? (page 97)
Is the firmware version for the network device the latest? (page 98)
●
Is the computer connected to a network device (such as a switch, a hub, or a router)? (page 98)
●
Did you configure the settings related to communication conditions on a network device (such as a
●
switch, a hub, or a router)? (page 98)
Are there any security limitations in the network? (page 98)
●
● Is the network stable? (page 98)
● Did you select the scanner in Scanner Selection Tool? (page 99)
● Is the communication status between the scanner and the computer stable? (page 99)
Is the scanner connected to another computer? (page 100)
●
Is the scanner's IP address correct? (page 100)
●
Is the IP address of the scanner used for other communication devices? (page 100)
●
Is the correct scanner name set for the image scanning application? (page 100)
●
If the problem still persists, check each item in
117) first, then contact the distributor/dealer where you purchased this product. Refer to the contact
information in the Contact List if supplied with this product, or refer to the contact information in the
Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
●
Is the scanner connected to a network device (such as a switch, a hub, or a router) via a LAN cable?
Solution
Connect the scanner to a network device (such as a switch, a hub, or a router) via a LAN cable. Also,
connect the LAN cable properly.
When the LAN cable is connected properly, take the following measures:
● Replace the LAN cable.
● Change the port on the network device, which the LAN cable is connected to.
● Change the transmission method for the network device to "full-duplex" or "half-duplex".
●
Is the network device (such as a switch, a hub, or a router) turned on?
Solution
Turn on the network device (such as a switch, a hub, or a router).
Also, check that there is no error or malfunction on the network device.
For errors that occur on the network device, refer to the manual of your network device.
Before You Contact the Scanner Service Provider (page
97
Troubleshooting