Table of Contents
Advertisement
15.EEC System
Inspection of the flow rate of the canister vacuum valve
1. Using a vacuum pump connecting to the vacuum tube of canister and apply
45m/mHg of negative pressure.
2. Apply pressure to the emission control valve of canister, if the flow rate
above 9.4 litters per minute that means the valve is in good condition,
otherwise the canister should be replaced.
NOTE: Always using the pump by manual, do not apply high pressure for
testing to prevent the valve from malfunction.
Installation of canister
1.Installation is the reverse order to the dismantling.
2.Connect the tubes and circlips firmly.
NOTE: The tube should not be wrenched or crashed and never refit the canister.
XCITING S 400
14-7
Advertisement
Table of Contents
Troubleshooting
