9.Electrical Systems
XCITING S 400
Starting System
Starter Relay Inspection
Disconnect the starter relay wire connector.
And remove the starter relay.
Check for continuity between the yellow/red wire and green/yellow wire. There
should be continuity when the starter button is depressed. If there is no continuity,
check the starter button for continuity and inspect the wire.
Connect the electric meter to the starter relay terminals that connect to the
battery positive cable and the starter motor cable. Connect a fully charged battery
across the starter relay yellow/red and green/yellow wire terminals.
Check for continuity between the starter relay large terminals. The relay is normal
if there is continuity and hear sounds.
Warning: Do not apply the battery voltage jump for more than five seconds or the
relay may be damaged.
Do not over tight the nuts or the relay may be damaged.
9-24