Push Button (S1) - Infineon PROFET+2 12V Arduino Shield User Manual

™
PROFET +2 12V Arduino Shield
2 Board description
Figure 10 PROFET
2.5.5

Push button (S1)

The option to solder a SMD push button at the placeholder S1 is also available. Additionally, a resistor(R
kOhm) and a capacitor (C
J2/J3 setting, the push button is available either on the digital input D2 (P1.4) or on the analog input A0 (P2.6).
User Manual
™
+2 Arduino Shield with position of jumper J1
= 100 nF) are required to debounce the switch. Moreover, depending on the jumper
S1
16
= 82
S1
Rev. 1.00
2019-10-23