Chapter 2. Installing Cabinets; Procedure Of The System Installation; Figure 2.1 Configuration Of The Front Side Of The System - Samsung OfficeServ 7400 Installation Manual

CHAPTER 2.
This chapter describes how to install an OfficeServ 7400 cabinet on the ground, inside rack
or on a wall depending on the installation environment

2.1 Procedure of the System Installation

The procedure of system installation is as follows:
1) Install the OfficeServ SME cabinet on the ground, inside rack depending on the
installation environment.
2) Earth to the ground lug behind the basic cabinet.
3) Insert the LP board into the slot 0 of the basic cabinet. If there is an expansion cabinet,
insert the LP 40 board into the slot 0 of the expansion cabinet.
4) Mount interface boards into the universal slots(slot 1 through slot 11).
5) Connect an external battery.
6) Connect input power with AC 110/220 V.
© SAMSUNG Electronics Co., Ltd.
Installing Cabinets
Slot 0
Slot 1
Slot 3
Slot 4
Slot 6
Slot 7
Slot 9
Slot 10

Figure 2.1 Configuration of the Front Side of the System

OfficeServ 7400 Installation Manual
Slot 2
Slot 5
Slot 8
Slot 11
2-1