Before Use; Transport; Firmware - LINET Multicare Instructions For Use And Technical Description

8.4 Before Use

Prepare the bed for service as follows:
► Connect the bed to the mains.
► Charge the accumulator.
► Raise and tilt the mattress platform to the highest position.
► Lower and tilt the mattress platform to the lowest position.
► Check that the castors as well as main brake work correctly.
► Check that the bed extension works correctly.
► Check that it is possible to remove the head and foot boards.
► Check all of the functions on the control elements (Multiboard etc.).
► Check that the siderails function properly.
► Dispose of all packaging (see Disposal).

8.5 Transport

For a safe transport, observe the following:
► Ensure that no cables are run over when moving a bed.
► Ensure that the mains cable is attached with a hook (at the head board).
► Ensure that the castors are unlocked before moving the bed during the loading/unloading process (see Castor Control and
Bed Transport).
► Move the bed exclusively on suitable floor surfaces.
Suitable surfaces:
■ Tile
■ Hard linoleum
■ Poured flooring
Unsuitable surfaces:
■ Too soft, unsealed or defective flooring
■ Soft wooden flooring
■ Soft and porous stone floors
■ Carpeted floors with underlay
■ Soft linoleum
► For longer distances, ensure that the castor steering function (main control) is activated.
► Ensure that the brakes are released while moving the bed.

8.6 Firmware

The bed includes firmware that can be updated only by an authorised service technician.
This firmware is protected against unauthorised access by mechanical housing (tool is needed to access), by seal (com-
ponents with processor are sealed), by exclusive compatibility with an authorised software tool and by check of compati-
bility of the new firmware with the bed.
30 D9U001MC0-0101_16