Before Use; Installation; Usage - LINET HybriMatt 200 Instructions For Use Manual

2.1 Before Use

It is necessary to read the instructions for use before operating the mattress system.
„
Follow the instructions carefully.
„
Use the mattress system only as specified in this manual.
„
LINET shall not assume any responsibility for any damage or injury resulting from incorrect use.
„
Position the power supply cable so that there are no loops or kinks in the cable; protect the cable from mechanical wear and
„
tear. Improper handling of power supply cable can cause an electric shock hazard, other serious injuries or damage to the
mattress system.
Position the power supply cable so there is no risk of injuring the patient (e.g. choking hazard).
„
Regular inspection of the mattress interior to be carried out on a regular basis. Place power supply cable into the cable loops
„
with toggles on the mattress side.
In case of any problem please contact manufacturer for help at installation, service or if an unexpected event occurs.
„
HybriMatt Hybrid Mattress Replacement System is compatible with a bed whose mattress support platform is in accordance
„
with the HybriMatt 200 mattress and whose foot board can properly support the HybriMatt compressor.

2.2 Installation

Ensure that installation is performed in accordance with the instructions in this manual.
„
Ensure that maintenance is performed only by qualified personnel who have been trained by the manufacturer.
„

2.3 Usage

Ensure any user has read and understood the instructions for use completely before operating the product.
„
Only use the mattress system if it is in perfect working order.
„
Only use the system in clean environment.
„
Always hold the compressor with scoop handle when moving.
„
Only use the mattress system with the correct power supply.
„
Replace any damaged parts immediately with original spare parts only.
„
Do not exceed the maximum patient weight.
„
Do not use the compressor in near flammable gases. This does not apply to oxygen cylinders.
„
Do not cover the compressor while in use.
„
Do not place the compressor near extreme heat sources such as radiators.
„
Never handle the power plug with wet hands.
„
Disconnect the product from the outlet only by pulling the power plug. While pulling the power plug, always hold the actual
„
plug, not the cord.
Mattress and the compressor must be checked at least once a day. Check that:
„
the mattress is inflated to the required pressure.
„
the Low Pressure indicator is not pernamently illuminated.
„
In case of error refer to the chapter "System Faults".
The handles located on the both sides of the mattress cover are designed only for manipulation with the mattress without load
„
(without patient).
14 D9U003VHM-0101_00