Huawei NetCol5000-A User Manual page 69

ACC Precision Air Conditioner Controller
User Manual
Menu
Issue 02 (2016-11-30)
Parameter Description

Disallow on/off When the function is
via EMS disallowed, the EMS is not
allowed to start or shut down
the precision air conditioners.
Heat Enable indicates that the
electric heater will be started
when the ambient temperature
is lower than the certain
temperature range of the
temperature set point. Disable
indicates that the electric
heater will not be started.
Heat mode Sets the starting mode of the
electric heater.
Humid Enable indicates that the
electric humidifier will be
started when the ambient
humidity is lower than the
certain humidity range of the
humidity set point. Disable
indicates that the electric
humidifier will not be started.
Humid mode Sets the starting mode of the
humidifier.
Dehumid Enable indicates that the
dehumidification function will
be enabled when the ambient
humidity exceeds the certain
humidity range of the humidity
set point. Disable indicates
that the dehumidification
function will not be enabled.
Forced cooling When the control type is air
start temp
return or hot aisle, set the
temperature for forcibly
starting the compressor when
the maximum temperature for
the cold aisle or supply air
surpasses this value.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
increases, system 2 also
starts.
No.2 system first: When
cooling is required, system
2 starts first. After the
cooling requirement
increases, system 1 also
starts.
A Parameter Description
Default Value
No
Enable
Dehumid heat
Enable
Cooling and humid
Enable
25.0° C
63