KEB COMBIVERT R6-S Series Instruction Manual page 39

No. Name
CP.01 status display
E.SYn „ERROR synchronisation, phase allocation at commutation choke not correct
E. UP „ERROR underpotential, DC link voltage too low
No. Name
CP.02 actual line frequency
After switching on, the actual mains frequency is determined during the initialization phase.
Slow changes of the line frequency during the operation are recognized and displayed in
CP.02. CP.02 displays the actual regenerative frequency, if the COMBIVERT R6-S is in
"netof" status.
Resolution
0.01 Hz
No. Name
CP.03 AC current L1
CP.04 AC current L2
CP.05 AC current L3
Resolution
0.1 A
No. Name
CP.06 actual DC utilization
Resolution
1 %
No. Name
CP.07 peak DC utilization
Resolution
1 %
Meaning
positive values = clockwise rotating field
negative values = counterclockwise rotating field
Meaning
Display of the actual input current of the respective phase.
Meaning
Independent whether power supply or regenerative operation, the dis-
play indicates the actual utilization of the COMBIVERT R6-S. 100 %
correspond to the rated current of the COMBIVERT R6-S.
Meaning
Parameter CP.07 enables to recognize short-term peak utilization with-
in an operating cycle. For that the highest value of CP.06 is stored in
CP.07. The peak value memory can be cleared by pressing the UP and
DOWN key or over bus by writing any value you like to the address of
CP.07. Switching off COMBIVERT R6-S also clears the memory.
r/w Enter Origin
– – ru.00
r/w Enter Origin
– – ru.03
r/w Enter Origin
– – ru.08
– – ru.09
– – ru.10
r/w Enter Origin
– – ru.13
r/w Enter Origin
– – ru.14
US - 39