Introduction; Preface; Product Description - KEB COMBIVERT R6-S Series Instruction Manual

1.

Introduction

1.1

Preface

First we would like to welcome you as a customer of KEB and congratulate you on the purchase of this product.
You have decided on a product of the highest technical innovation.
The enclosed documents as well as the specified hardware and software are developments of KEB. KEB has
created these documents, hardware, and software and they are to the best of KEB's knowledge error free. KEB
reserves the right to change specifications without prior notice. This statement is not exclusive.
The icons used throughout this document have the following significance:
1.2

Product description

This instruction manual describes the power supply and recovery unit KEB COMBIVERT R6-S. The COMBIVERT
R6-S has the following technical features.
As a supply unit
• converts a three-phase input voltage into DC voltage.
• supplies a single KEB frequency inverter or multiple units via DC interconnection.
• can be connected in parallel, if higher supply power is required.
• increases the stability of the DC Bus voltage in shared DC Bus applications.
As a regeneration unit
• returns the excess energy from generating operation (i.e. overhauling load) to the utility supply system.
• reduces the net energy demand.
• reduces the heat dissipation.
• is environmentally friendly.
• replaces braking resistor and braking transistor.
• is cost saving and space saving.
The COMBIVERT R6-S is generally protected against over current, ground fault and high temperature. Appropriately
dimensioned DC fuses protect the DC Bus circuit against short-circuit. The following accessories are necessary
for operation with the COMBIVERT R6-S:
• Commutation choke
• HF filter (for observance of European EMC standard)
Danger
Warning
Caution
Pay Attention
Important Warning
Information
Help
Tip
Introduction
US - 5