Selfcalibration Functions - Eizo ColorEdge PROMINENCE CG3146 User Manual

4-1. SelfCalibration functions

Set the details for "SelfCalibration".
Function
Execute
Mode Settings Standard Mode
Schedule
36
Chapter 4 SelfCalibration
Settings
-
On
Off
Advanced CAL1 On
Mode CAL2 Off
CAL3
Start time Power Save
Immediately
Application
Off
Frequency Daily
Weekly
Monthly
Quarterly
Biannually
Annually
Usage Time
Description
SelfCalibration can be executed manually
regardless of the schedule.
Note
• After selecting "Execute", warming up (after
the power to the monitor is switched on,
leaving the monitor on for a certain period of
time until the display becomes stable) may be
executed before the built-in calibration sensor
comes out.
Switch between enabling/disabling
SelfCalibration in Standard Mode.
Switch between enabling/disabling
SelfCalibration in Advanced Mode.
Select the timing to execute SelfCalibration upon
reaching the time set in the schedule.
• "Power Save"
To be executed under any of the following
conditions.
- When the monitor is in "Power Save" mode
or power is off at the set time.
- The monitor shifts to the power saving
mode or the power is turned off when the
set time in the schedule is exceeded.
• "Immediately"
SelfCalibration is executed immediately at
the set time.
• "Application"
Execute SelfCalibration according to the
timing set using ColorNavigator Network. For
details on ColorNavigator Network, refer to
our web site (www.eizoglobal.com).
• "Off"
SelfCalibration is not executed.
Select the SelfCalibration execution cycle.