Table of Contents
Advertisement
Function
SDI
Time Code
Settings
Settings
Interlace / PsF Auto
●
Color
The setting details differ depending on the color mode selected.
When the color mode is Standard Mode (BT.2020 / BT.709 / DCI-P3 / PQ_BT.2100 /
PQ_DCI-P3 / HLG_BT.2100 / SYNC_SIGNAL)
Each color mode setting can be adjusted according to personal preference.
Attention
• The same image may be seen in different colors on multiple monitors due to differences between individual
monitors. Make fine color adjustment visually when matching colors on multiple monitors.
Note
• If "Color Mode" is "SYNC_SIGNAL", the "Brightness", "Gamma (EOTF)", and "Color Gamut" are automatically
set according to the input signal and cannot be changed.
• Use the values shown in "cd/m
Settings
Time Code
The time code can be set.
Format
• Time Code
Position
If this function is set to "On", the time code is displayed.
Size
• Format
You can choose either "VITC" or "LTC" for the format of the time
code.
• Position
You can choose either "Top" or "Bottom" for the position to
display the time code.
• Size
You can choose either "Small" or "Large" for the size of the time
code.
When an SDI signal other than progressive is input, the display
Interlace
format can be set.
PsF
2
" and "K" as a guide only.
Description
Chapter 3 Advanced Adjustments/Settings
19
Advertisement
Table of Contents
