Table of Contents
Advertisement
Function
Luminance Warning
Co-View
Blue Only
Function
Marker Marker 1
Off
On
On (3 division grid)
Marker 2
Off
Marker 3
On
Marker1
Type
Settings
Marker2
Settings
Marker3
Settings
Aspect
Aspect
(User)
Settings
Off
You can check areas with a brightness that is higher than the
On (Yellow)
brightness that is set for the PQ Option function for the input signal
On (Magenta)
(areas where clipping occurs).
Note
• This function and "BT.709 Gamut Warning" cannot be enabled at
the same time. If this function is set to "On", the "BT.709 Gamut
Warning" function is automatically set to "Off".
Off
If this function is set to "On", the monitor can be easily viewed at
On
a wider angle, such as when multiple people are looking at the
monitor at the same time.
Note
• If small dots or fine lines that should be brighter are displayed a
little too darkly, there are cases when this problem can be solved
by setting this function to "Off". However, a halo effect might
occur when this function is set to "Off".
Off
Use this function to check the noise.
On
Settings
If this function is set to "On", markers are displayed. If "On (3
division grid)" is set, boundary lines are displayed that divide
the image into three equal parts with Marker 1 and Marker 1.
Note
• If "On (3 division grid)" is set, "Marker 2" and "Marker 3" are
disabled.
If this function is set to "On", markers are displayed.
Aspect
You can select the position and size of the marker.
Dots
(Center)
Dots
(Free)
4:3
You can set the aspect ratio for the displayed marker.
13:9
14:9
15:9
16:9
21:9
1.85:1
2.35:1
2.39:1
User
1.00:1 to
You can set the aspect ratio for the displayed marker freely.
3.00:1
This can only be set when "User" is selected for "Aspect".
Description
Example: Setting On (Magenta)
Description
Chapter 3 Advanced Adjustments/Settings
29
Advertisement
Table of Contents
