VeEX OTDR Series User Manual page 91

The Event table is displayed automatically when the Events tab is selected. It can be
minimized by tapping the plus symbol just above the left of table. This optimizes the display
area and allows better viewing of the OTDR trace.
Use Up/Down arrows to navigate the event table and to display or move to the highlighted
event.
Use the green Left/Right arrows to move the marker between the start and end of fiber being
tested.
To maximize the Event table, select the cross symbol again.
The right green brackets (Span Start) indicate the 0km location and the left
(Span End) is the end. The reported total loss and ORL is from this area of the
trace only. For example, if there is a 1000m launch cable between the OTDR
and FUT, then the Span Start of 0km is set at the end of 1000m.
OTDR Series e-Manual, RevE00
Event Table – MPO test
Page 91 of 128