VeEX OTDR Series User Manual page 80

5. On the OTDR screen, tap Start to begin the test. The screen switches to the Measure tab
screen automatically. When the V-Scout test plan is complete and OTDR traces performed,
view the V-Scout link map on the LinkMap tab.
To set up and use the automated V-Scout mode:
1. Select the Autosave parameters in the Setup tab. See the
for more details.
Parameters
2. Tap the green Start button. Elapsed time and acquisition wavelength are indicated below
the red Stop button.
3. When the test is complete, the Stop button will revert back to a green Start button. If
needed, tap Stop to terminate the measurement manually.
4. If Autosave is enabled with Ask Before Save checked, an AutoSave window appears
asking if the results should/how be saved. If Ask Before Save was not checked, results will
be saved automatically using the parameters previously set for AutoSave.
5. When the V-Scout test plan is complete and OTDR traces performed, view the V-Scout link
map on the LinkMap tab.
OTDR Series e-Manual, RevE00
OTDR Viewer Setup Screen: V-Scout Profiles mode
Section 7.5 Autosave
Page 80 of 128