Usb Interface - Quectel BG96 Series Hardware Design


Keep placement of (U)SIM card connector as close to the module as possible. Keep the trace length
as less than 200mm as possible.

Keep (U)SIM card signals away from RF and VBAT traces.

Assure the ground between the module and the (U)SIM card connector short and wide. Keep the
trace width of ground and USIM_VDD no less than 0.5mm to maintain the same electric potential.
Make sure the bypass capacitor between USIM_VDD and USIM_GND less than 1uF, and place it as
close to (U)SIM card connector as possible. If the system ground plane is complete, USIM_GND can
be connected to the system ground directly.

To avoid cross-talk between USIM_DATA and USIM_CLK, keep them away from each other and
shield them with surrounded ground. USIM_RST should also be ground shielded.

In order to offer good ESD protection, it is recommended to add a TVS diode array with parasitic
capacitance not exceeding 15pF. In order to facilitate debugging, it is recommended to reserve series
resistors for the (U)SIM signals of the module. The 33pF capacitors are used for filtering interference
of GSM 900MHz. Please note that the (U)SIM peripheral circuit should be close to the (U)SIM card
connector.

The pull-up resistor on USIM_DATA line can improve anti-jamming capability when long layout trace
and sensitive occasion are applied, and should be placed close to the (U)SIM card connector.

3.9. USB Interface

BG96 contains one integrated Universal Serial Bus (USB) interface which complies with the USB 2.0
specification and supports high-speed (480Mbps) and full-speed (12Mbps) modes. The USB interface is
used for AT command communication, data transmission, software debugging and firmware upgrade. The
following table shows the pin definition of USB interface.
Table 10: Pin Definition of USB Interface
Pin Name Pin No.
USB_VBUS 8
USB_DP 9
USB_DM 10
GND 3
For more details about USB 2.0 specification, please visit http://www.usb.org/home.
The USB interface is recommended to be reserved for firmware upgrade in customers' designs. The
following figure shows a reference circuit of USB interface.
BG96_Hardware_Design
I/O Description
PI USB connection detection
IO USB differential data bus (+)
IO USB differential data bus (-)
Ground
LTE Module Series
BG96 Hardware Design
Comment
Typically 5.0V
Require differential
impedance of 90Ω
Require differential
impedance of 90Ω
35 / 78