Set-up program
When no application program has been uploaded onto the
Integrated Controller and Operator Panel, or when the dial is
positioned on F, the following happens:
1.
The Gefran logo appears on the screen.
2.
The operating system is loaded (this takes about 1mi).
3.
The Main Menu of the set-up program appears.
The set-up program allows configuration of the device and
to obtain information on it.
The configurations to be carried out when using the control-
ler for the first time are:
1.
Regulation of the current date and time.
2.
Calibration of the touchscreen display.
3.
Uploading of the application program.
When uploading an application program onto the controller,
the set-up program is no longer shown.
To access the set-up program again after uploading an ap-
plication program onto the Integrated Controller and Opera-
tor Panel, proceed as follows:
1.
Switch off the controller.
2.
Shift the controller dial to position F (figure16)
GF_VEDO SL 35CT
Figure 16 - GF_VEDO SL Dial
3.
Switch the controller on again. After the initial start pha-
se, the main menu of the set-up program appears.
4.
Operate as for the set-up program and then switch off
the controller.
80991C_MHW_GF_VEDO SL_09-2017_ENG
ENTRY INTO SERVICE
GF_VEDO SL 70CT
GF_VEDO SL V70CT
5.
Shift the controller dial to its previous position.
6.
Switch the controller again. After the initial start phase,
the application program screen appears.
Main Menu
The version of the set-up program installed appears in the
top right corner.
The Configuration button allows access to the device con-
figuration procedures.
The Information button allows access to information on the
firmware and communication protocols installed.
The Exit button allows a return to the application program,
if installed.
Configuration
The HOME button in the top left corner allows a return to
the Main Menu.
The Network button allows access to the device configura-
tion procedures.
The Display button allows access to information on the
firmware and communication protocols installed.
The Touchscreen Calibration button will allow future ac-
cess to the procedure for the calibration of the touch
screen without using the dial.
17