Sub-Zero PRO 48 Series Installation Manual page 14

PRO 48 Installation
Drawer Adjustment
Make sure all drawers of the PRO 48 are properly aligned
for function and appearance. If not, vertical and horizontal
adjustments can be made to the drawers.
The drawer must be removed to make vertical and hori-
zontal adjustments. To remove the drawer, pull the drawer
all the way out until it stops, lift up evenly on both sides of
the drawer front and pull out.
To reinstall the drawer, raise the front of the drawer and
place onto the drawer slide tracks. Be sure to engage the
front of the drawer slide with the drawer assembly. Make
sure the drawer is fully engaged onto the tracks. Check
alignment of the drawer closer. If the closer catch does
not align with closer pin, adjust the position of drawer
closer.
VERTICAL ADJUSTMENT
1) Loosen the drawer slide mounting screws.
7
2) Using a / " open-end wrench, turn the adjustment
16
screw until proper alignment is achieved. Refer to the
illustration below.
3) After adjustment, tighten all screws and reinstall the
drawer. Check the drawer seal for proper gasket
seating.
MOUNTING
SCREW
ADJUSTMENT
SCREW
Vertical adjustment.
HORIZONTAL ADJUSTMENT
1) Loosen the two front drawer slide screws. Refer to the
illustration below.
2) Move adjustment blocks to desired position and
tighten screws.
3) Release the rear adjustment block by disengaging the
snaps.
4) Move the block forward to shift drawer to the right, and
back to shift drawer to the left. Each position will move
the drawer .030" (.8). Both sides should be moved in
the same direction.
5) Snap the block over the pins located on the rear
adjuster. Refer to the illustration below.
6) After adjustment, tighten all screws and reinstall the
drawer. Check the drawer seal for proper gasket
seating.
REAR
ADJUSTMENT
BLOCK
SLIDE
SCREW
Horizontal adjustment.
14