Sub-Zero PRO 48 Series Installation Manual page 12

PRO 48 Installation
Water Line Connection
Approximately 3' (.9 m) of
to the ice maker with a preassembled
connection at the end. This tubing is located under the
unit.
The water line fitting connection kit, provided with the unit,
1
contains a / " compression sleeve and nut for connection
4
to the household water line. Place the sleeve and nut on
the water line and fasten to the connection at the end of
the tubing under the unit. Do not over tighten. Check all
water line fittings for leaks. Make sure the drain pan can
be removed without water line interference.
Purge the water line prior to final connection to the unit.
This will remove any debris that may be present in the
tubing from installing the new water line.
IMPORTANT NOTE: If a reverse osmosis system is used,
it is recommended that the water filtration system be
bypassed. Refer to water filter bypass mode on page 16.
IMPORTANT NOTE: Let your customer know that the ice
maker will not produce ice immediately, and that the first
few batches of ice produced should be discarded. Allow
24 hours for proper ice production.
IMPORTANT NOTE: Water lines must not be exposed to
freezing temperatures. Exposure could cause damage to
the unit and home.
1
/ " plastic tubing is connected
4
1
/ " compression
4
Level the Unit
Once the unit is in position, extend the front leveling legs
down by turning the legs counterclockwise and adjust the
height. The rear height adjustment can be made from the
front of the base. Use a
5
rollers. Turn the / " hex bolt clockwise to raise the unit or
16
counterclockwise to lower it. Refer to the illustration below
for location of the rear roller base adjustment.
When the unit is properly leveled, door and drawer adjust-
ments are less likely to be necessary.
IMPORTANT NOTE: Be sure to reference leveling of the
unit to the floor and not surrounding cabinetry. This could
affect the operation of the unit, such as door closing.
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the floor.
REAR
ADJUSTMENT
FRONT
LEVELING LEG
Rear roller base adjustment.
5
/ " socket to adjust the rear
16
12