Sub-Zero PRO 48 Series Installation Manual page 10

PRO 48 Installation
Unpack the Unit
Uncrate the PRO 48 unit and inspect for any damages.
Remove the wood base and discard the shipping bolts
and brackets that hold the wood base to the bottom of the
unit. Remove and discard all packing materials.
IMPORTANT NOTE: Do not discard the kickplate, anti-tip
bracket and hardware or corner protectors. These items
will be needed for installation.
Retract the front leveling legs all the way up to allow the
unit to be moved into position more easily. You will extend
the front leveling legs down and make adjustments once
the unit is in position.
Remove the drain pan from the base of the unit to avoid
damage to the drain pan, and allow for proper placement
of the appliance dolly.
Grille Removal
In order to prevent damage to the PRO 48 grille, the top
grille assembly should be removed prior to moving the
unit.
To remove the grille assembly, pull out on the bottom edge
of the grille and tilt the grille frame forward. Disconnect the
network cables which connect the exterior temperature
displays on the grille to the display module. Cut the two
white cable ties which attach the network cables to the
right grille support and disconnect the cables. The cable
ties should be replaced with the extra cable ties provided,
once the unit is properly installed. Remove the three grille
bolts from base of the grille and the upper grille screw.
Remove the grille assembly. Refer to the illustrations
below.
Reverse this procedure to reinstall the grille assembly.
Lift grille assembly.
GRILLE
SCREW
NETWORK
CABLES
GRILLE BOLT
Grille removal.
10