Sub-Zero PRO 48 Series Installation Manual page 13

PRO 48 Installation
Door Adjustment
Make sure both doors of the PRO 48 are properly aligned
for function and appearance. If not, adjustments can be
made to the cabinet hinges.
IMPORTANT NOTE: The unit must be properly leveled
before adjusting hinges.
If the PRO 48 is properly installed and leveled, it may still
be necessary to adjust doors left to right. Adjustments are
performed at the top and/or bottom cabinet hinges.
HINGE ADJUSTMENT
1) Lift up the vent portion of the top grille.
2) Remove the door by opening to approximately 90° and
lifting the door off cabinet hinges. Refer to the illustra-
tion below.
3) Remove hinge pins.
4) Loosen the two cabinet hinge screws
Refer to the illustration below.
5) Reinstall hinge pins and door. With the door open,
using the Allen wrench provided, turn the adjustment
screw to adjust the cabinet hinge. Refer to the illustra-
tion below.
6) Close the door and check alignment. If additional
adjustment is required, repeat these steps until the
door is properly aligned.
HINGE
PIN
CABINET
HINGE
Door removal.
1 1
/ to / turn.
4 2
HINGE
SCREW
ADJUSTMENT
SCREW
Hinge adjustment.
The doors of the PRO 48 are very heavy. Use care when
removing them.
IMPORTANT NOTE: When adjusting hinges, it is important
to keep hinges parallel to the face of the door and side of
the cabinet. Excessive misalignment will result in door
light switch malfunction. If the switch is not activated, the
fan will not operate and lights will remain on. This will
result in elevated cabinet temperatures. After hinge adjust-
ments are made, check for proper functioning of door light
switch. Refer to the illustration below.
LIGHT
SWITCH
Door light switch.
13
subzero.com/specs