Table of Contents
Advertisement
Follow the steps in
Section 4.3.2 Saving Changes
4.2.4 Naming the Transmitter Unit
Modify the name of the unit through the Transmitter. The name entered on the Transmitter will
display on the Receiver unit.
Using the arrow down button, scroll down to *System as shown below.
Using the right arrow, scroll right until Tx Ctrl is displayed as shown below. Then press enter.
Revision D
Load Defaults
Yes/No=
*System
Tx Ctrl
Name=
YES
to save your changes.
TXUnit01
17
December 2012
Advertisement
Table of Contents
