Cisco IE 5000 Product Documentation And Compliance Information page 3

Installing the Switch—Installation du commutateur
English
These sections explain how to install the switch. See the Cisco IE 5000 Switch Hardware Installation
Guide for more information.
For instructions on how to install the switch in a hazardous environment, see the
Note
of the Cisco IE 5000 Switch Hardware Installation Guide on Cisco.com.
When installed in a Class I. Div/Zone 2 hazardous location environment, this equipment must be
Caution
installed in a min. IP54, ATEX certified enclosure.
Airflow around the switch must be unrestricted. To prevent the switch from overheating, there must be
Caution
the following minimum clearances:
- Top and bottom: 2.0 in. (50.8 mm)
- Sides: 2.0 in. (50.8 mm)
- Front: 2.0 in. (50.8 mm)
Contact your Cisco Technical Assistance Centre (TAC) if tighter spacings are required.
When installed in a Class I. Div/Zone 2 hazardous location environment. this equipment must be
Caution
installed in a pollution degree 2 environment per IEC 60664-1)
This equipment is suitable for use in Class I. Division 2 . Groups A, B . C. D. or only nonhazardous
Caution
locations.
Exposure to some chemicals could degrade the sealing properties of materials used in the sealed
Warning
relay device. Statement 381
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of : 140°F (60°C) Statement 1047
When you connect or disconnect the power and/or alarm connector with power applied, an
Warning
electrical arc can occur. This could cause an explosion in hazardous area installations. Be sure
that all power is removed from the switch and any other circuits. Be sure that power cannot be
accidentally turned on or verify that the area is nonhazardous before proceeding. Statement 1058
78-100604-01
Product Documentation and Compliance for the Cisco IE 5000 Switches—
Documentation produit et conformité pour les commutateurs Cisco IE 5000
"Installation" chapter
3