Cisco IE 5000 Product Documentation And Compliance Information page 18

If you have a low-voltage DC power-supply module, connect the wires to the terminals labeled Lo. If
Note
you have a high-voltage DC power-supply module, connect the wires to the terminals labeled Hi.
To connect the AC power:
Step 7
a.
b.
Figure 1-17
To connect the DC power:
a.
b.
Figure 1-18
Product Documentation and Compliance for the Cisco IE 5000 Switches—
Documentation produit et conformité pour les commutateurs Cisco IE 5000
18
Connect the line wire into the terminal screw labeled L and the neutral wire into the terminal
screw labeled N.
Make sure that you cannot see any wire lead. Only wire with insulation should extend from the
terminal screw.
Connecting the Wires to the High-Voltage AC Power (PSU1)
1 0
4 0 0 - 2
V ~ ,
5 0 -
H z , 6 0
2 . 2
A
1 0
0 - 2
V ~ , 4 0
5 0 -
6 0
H z ,
A 2 . 2
C is c o IE 3 0 C is C
c o
IE
3 3 0 1
1 0
0 0
Connect the positive wire into the terminal screw labeled +, and the negative wire into the
terminal screw labeled –.
Make sure that you cannot see any wire lead. Only wire with insulation should extend from the
terminal screw.
Connecting the Wires to the Low-Voltage DC Power (PSU2)
C is c o IE C
is
c o
IE
3 0 1 0 3 0 1
1
0 0
78-100604-01