Cisco IE 5000 Product Documentation And Compliance Information page 10

Installing the Power-Supply Module in the Switch
We recommend that power be off at the AC or DC circuits. Locate the circuit breakers, turn them OFF,
Step 1
and tape them in the OFF position.
Note
Use a Phillips screwdriver to loosen the two captive screws of the blank power-supply module and gently
Step 2
pull it out. See
Figure 1-4
C i sco I E
301 0
Sw i t ch Ser
i es
Figure 1-5
C i sco C onn
Sw i tch 250
Insert the power-supply module into the slot, and gently push it in. See
Step 3
module should be flush with the switch.
Figure 1-6
Use a ratcheting torque screwdriver to torque each screw to 8–10 in-lb (0.904-1.13 Nm).
Step 4
Product Documentation and Compliance for the Cisco IE 5000 Switches—
Documentation produit et conformité pour les commutateurs Cisco IE 5000
10
If the power is not off at the AC or DC circuit breaker, do not touch the power-input terminal.
Figure 1-4 and
Loosen the Screws on the Power Supply Blank
Remove the Power Supply Blank
ect ed G ri
d
0 Ser i es
Insert the Power-Supply Module
Figure 1-5.
Figure 1-6. The power-supply
78-100604-01