Cisco IE 5000 Product Documentation And Compliance Information page 24

Hide thumbs Also See for IE 5000:

Removing the Power-Supply Module—Retrait du module

d'alimentation

English

The power supply modules are NOT hot-swappable. Turn off the input power to the switch before

removing either power supply modules.

Sparking may occur if power is not turned off while swapping the power supply module. This can cause

Caution

an explosion in hazardous environment

Locate the circuit breakers, turn them OFF and tape them in the OFF position.

Step 1

Note

Verify that the PSU LED and PSU OK LED is blinking red or is off.

Step 2

Use a Phillips screwdriver to loosen the captive screws that secure the power-supply module to the

Step 3

switch. See

Hot surface. Statement 1079

Warning

Figure 1-25

C i sco I E

301 0

Sw i t ch Ser

i es

Product Documentation and Compliance for the Cisco IE 5000 Switches—

Documentation produit et conformité pour les commutateurs Cisco IE 5000

If the power is not off at the AC or DC circuit breaker, do not touch the power-input terminal.

Figure

1-25.

Removing the Screws

78-100604-01