Table of Contents
Advertisement
• CMOS imaging sensors
• ASX340AT by Aptina / ON Semiconductor and M12 lens
holder
• OVM7692 camera module by Omnivision
• RF Wireless
• 4 x 2 connector
• 0.05" socket
• Universal Asynchronous Receiver/Transmitter (UART1)
• FTDI FT232RQ USB to UART converter
• USB Mini B connector
• USB interface
• Micro AB connector
• RESET controller
• Analog Devices ADM6315 microprocessor supervisory
circuits
• Debug (JTAG/SWD/SWO) interface
• JTAG/SWD/SWO 10-pin 0.05" header for use with Analog
Devices emulators
• LEDs
• Two LEDs: one board status (yellow), one SYS_FAULT
(red)
• Push buttons
• Four push buttons: one reset, one wake I/O, and two GPIO
ADZS-BF707-BLIP2 Board Evaluation System Manual
Preface
xi
Advertisement
Table of Contents
Need help?
Do you have a question about the ADZS-BF707-BLIP2 and is the answer not in the manual?