Fullwood M2erlin Operating Instructions For Safe Use page 66

Ref / Pt.No: 294130
Revision: C
Date: 24-Mar-17
25 info MM_SENSOR
26 info CLEAN_LOW
_TEMP
27 info CHEMICALS
28 fatal MILKPUMP
29 error/info MILKING
_ABORTED
30 info CONNECTION
_FAILURE
31 info POWER_
FAILURE
32 info MILKING_
PAUSE
294130
Operating Instructions for Safe Use
Fullwood M²erlin
Milk meter is not seeing Milk
(0.8kg) in Merlin within the milk
meter alarm interval (default 60
sec), while sufficient milk flow is
present.
Since Merlin Facelift
By using value 0 for the interval
this check can be disabled.
Not used
No Data
Merlin cannot finish the milking.
Problems with emptying the milk
reservoir or resetting the milk
meter.
Milking aborted by arm control
Box when none of the Failed
Milking End Results are valid.
Milking End Result is first send
as Info, after a number of
failures in a row the alarm is
promoted to Error.
Generated when the Emergency
Stop input is activated
In case the system is set in
pause by the delivery line longer
As soon as the alarm Milk meter is not seeing
is triggered, the Milk (0.8kg) in Merlin
milking will be within the milk meter
terminated and the alarm interval (default
Merlin will go into 60 sec), while sufficient
error mode. milk flow is present.
- Since Merlin Facelift -
By using value 0 for the
interval this check can
be disabled.
Not used Not used by M2.
No Data Not used by M2.
An error will be Milk vessel is not
generated Merlin will emptied within the set
stop all actions. time (default 5 minutes)
after the milk pump has
been started.
After 3 aborted Milking is aborted by the
milkings in a row an 'old' arm (Possibly
error will be triggered by the user).
generated and the
Merlin will be put in
pause (Cleanings will
be executed).
No Data No Data
Someone pushed Emergency stop buttons
one or both of the input detected.
emergency stop
buttons and/or
problem with wiring.
Error will be Pause is taking longer
generated. as the set value (Default
Check milk meter and
reset alarm.
Not used
No Data
Check milk pump and
level sensors and reset
alarm.
Check system and reset
alarm.
No Data
Unlock emergency stop
button and/or verify wiring
emergency stop buttons.
Check system and reset
alarm.
Page 66 of 81