Pedometers; Removal Of The Pedometer; Storage Of Pedometers - Fullwood M2erlin Operating Instructions For Safe Use

Table of Contents

Advertisement

Ref / Pt.No: 294130
Revision: C
Date: 24-Mar-17
8.2

Pedometers

Attach a pedometer to the front leg of every cow in the herd; all animals must carry the
pedometer on the same leg, check with the installation engineer which leg is preferred.
Record every transponder number against the cow numbers (last 4 digits) - to enter onto the PC
later.
The pedometer must rest on the ankle of the leg and 'rotate' freely.
The strap should be fitted loosely. As a guide, an object the size of a finger should fit in-
between the strap and the leg, as depicted below.
8.2.1

Removal of the Pedometer

Fullwood Ltd recommends that the strap is cut and a new one used. Once fitted, it is difficult to
remove straps by prizing out the plastic wedge while attached to the cow.
Allow for growth of heifers. It is recommended to remove the pedometer as a matter of routine
when drying off. Re-attach with a new strap.
8.2.2

Storage of Pedometers

Incorrect storage of pedometers results in a reduced battery life, never store;
On their side
Upside down
Within 3 metres of an active antenna
Within 3 metres of a frequency controller device, e.g. a PC monitor
Within 3 meters of a source of heat, e.g. radiator.
Never blast pedometers with warm or hot water or soak; this will have a negative effect on their
function. (Please refer to pedometer instruction leaflet.006733)
294130
Operating Instructions for Safe Use
Fullwood M²erlin
Correct arrow up
Correct arrow up
Incorrect arrow down
Incorrect arrow down
Page 34 of 81

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M2erlin and is the answer not in the manual?

Related Products for Fullwood M2erlin

Table of Contents

Save PDF