Table of Contents
Advertisement
Chapter 9 MAINTENANCE AND CHECK
9.2 MAINTENANCE OF EACH UNIT
9.2.1 SCANNER UNIT NKE-2043, 2063A/AHS, 2103-4/4HS/6/6HS
After the work, turn "ON" the scanner unit safety switch.
➢
Precautions in Mounting the Cover
When the cover is removed for regular checkup and replacement of parts and refitted after
such work, the procedures of fastening bolts shall be taken with the following precautions:
⚫
The proper fastening torque of the fitting bolts (M8) is 1176 to 1470 N•cm (120 to
150kgf•cm) (which makes the inside water-tight and protects the packings against
permanent compressive strain). The packings start producing from the cover at a torque of
approximately 1470N•cm (150kgf•cm). Do not fasten the bolts with a torque exceeding the
specified value. Otherwise, the screws may be broken.
⚫
Use an offset wrench of 11 mm × 13 mm or a double-ended wrench of 13 mm × 17 mm
(not longer than 200 mm).
⚫
Screw all the bolts by hand first to prevent them playing, then fasten them evenly in order
not to cause one-sided fastening. (Fasten the bolts with 25% of the required torque at the
first step.)
*: Fasten the bolts in the diagonal order.
4-M5 (stainless steel) bolt
Tightening torque: 120 to 150 kgf/cm
186
DANGER
When conducting maintenance work on the antenna, make sure to
turn its main power off.
Failure to comply may result in electrocution or injuries.
Make sure to turn off the antenna operation switch.
Failure to comply may result in injuries caused by physical
contact with the rotating antenna.
Do not touch the radiator. Even if the power is turned off, the radiator
may be rotated by the wind.
①
④
⑤
③
NKE-2043 Cover Bolt
⑥
Tightening Procedure
②
Advertisement
Table of Contents
