JRC JMA-3400 Series Instruction Manual page 247

Alarm Code Alarm Name
AIS(Alarm032)
D044
AIS(Alarm035)
D045
Set Gyro
D046
DSP(Video)
D047
DSP(Trigger)
D048
DSP(AZI)
D049
DSP(HL)
D050
DSP Error
D051
LAT(Out of Bounds)
D052
TT(Out of Range)
D053
Flash ROM Error
D055
USB Error
D056
SD Error
D057
Alarm Name
Area1(Approach)
Area1(Secession)
Area1(Out of Range)
Area2(Approach)
Area2(Secession)
Area2(Out of Range)
TT(CPA/TCPA)
TT(New Target)
TT(Lost)
Dragging anchor
GPS(Error)
GPS(HDOP)
TM Reset
No Heading Data
On Preheating
Short Interval
Error Occurring
Max Point
File Not Found
USB Memory Not Set
Chapter 9 MAINTENANCE AND CHECK
Class Description
For AIS function=ON, an error from the AIS receiver is
Alarm
received(ALR).
For AIS function=ON, an error from the AIS receiver is
Alarm
received(ALR).
Requires setting of true bearing.
Status
DSP detects VIDEO error.
Alarm
DSP cannot receive TI interrupt.
Alarm
DSP cannot receive BP interrupt.
Alarm
DSP cannot receive BZ interrupt.
Alarm
Abnormal operation(infinite loop) of DSP.
Alarm
The own ship's latitude is 80 degrees or more (indicating that
some functions are limited). Display AIS, waypoint, mark/line,
Caution own ship trail, etc. for 80 degrees or more.
Input operations for 80 degrees or more
( refer to "High Latitude "alarm)
TT is too far to be tracked.
Alarm
Initialization error of flash ROM file system during startup.
Alarm
Initialization error of USB during startup.
Alarm
Chart SD card reading error.
Class Description
Echo in area1.
Alarm
No echo in area1.
Alarm
Rectangle area 1 is out of range.
Alarm
Creation of area 1 is out of range.
Echo in area2.
Alarm
No echo in area2.
Alarm
Rectangle area 2 is out of range.
Alarm
Creation of area 2 is out of range.
TT is changed to a dangerous ship
Alarm
TT is automatically acquired.
Alarm
TT is lost.
Alarm
The ship has left the dragging anchor monitoring area.
Alarm
Failed to set GPS.
Status
Received excessive HDOP value beyond the setting.
Caution
For TM, the own ship position is out of 40% of the radius of PPI.
Status
Cannot function because own ship heading is not available
- Operations for specifying TT acquisition/numerical display
Status
- Changing to TM
- Changing to N Up/C Up
Transmission operation during preheating
Status
Transmission operation in the interval of 1 second or less
Status
between standby and transmission
Transmission operation during prohibition of transmission caused
Status
by scanner error
Exceeded the maximum number of marks.
Status
File does not exists.
Status
USB memory does not exists.
Status
199