JRC JMA-3400 Series Instruction Manual page 248

Chapter 9 MAINTENANCE AND CHECK
Alarm Name
SD Memory Not Set
File Read Error
File Write Error
Not Enough Space
Format Error
Num of files Over
File Erase Error
TT(Max Target)
Unsetting
Invalid Data
In Operation
No HDG/POSN Data
Not Allowed
Range Scale Limit
No Valid Data
200
Class Description
SD memory does not exists.
Status
Failed to load the file.
Caution
Failed to write the file.
Caution
Insufficient capacity.
Status
Failed to format
Caution
Writing data to the USB memory in which the number of the file
Caution
has reached to the maximum.
Failed to delete the file
Caution
Manually acquired when the number of acquisition reached
maximum.
Detected when DSP tries to acquire 11 targets or more. DSP
Status
notifies the maximum target alarm occurrence of automatic
acquisition tot the TT process task, then the TT process task
notifies it to the alarm task.
Zone creation operations for guard zone = Off
EBL bearing setting while EBL is off
Floating setting while EBL/VRM is off
Status VRM range setting while VRM is off
Manual tuning setting while automatic tuning is on
AIS operations while AIS function is off
TT operations while TT function is off
Cannot function due to invalid value
Status
- Invalid code is input for the code input screen
This operation is disabled due to another operation
- Setting enable/disable and level during guard zone creation
- Operations for on/off during VRM range setting
Status - Operations for PRF tuning during manual tuning operations
- Setting for automatic/manual mode during manual tuning
Operations
- Operations for manual tuning during PRF tuning operation
Cursor operations when own heading or latitude/longitude is
disabled
- MOB input
- Event mark input
- Inputting/erasing/moving marks
Status
- Inputting/erasing/moving/inserting lines
- AIS numerical display/destination ship/retrieved vessel
Selection
- Creating latitude/longitude guard zone.
- TLL transmission for cursor.
Operations for inserting by selecting the end point in the line list.
Operations for switching to H-UP during TM (When heading is not
Status
available, temporarily changed to RM-HUp, therefore, message
is disabled.)
Operations functionally restricted for certain range.
Off center operations in range where off center is not available.
Status
TM setting operations in range where TM setting is not available.
Operations without data.
Status