Steelcase Machine and Typewriter unit 41-ATT Assembly Directions
  1. Manuals
  2. Brands
  3. Steelcase Manuals
  4. Indoor Furnishing
  5. Machine and Typewriter unit 41-ATT
  6. Assembly directions
Steelcase Machine and Typewriter unit 41-ATT Assembly Directions

Steelcase Machine and Typewriter unit 41-ATT Assembly Directions

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Attaching a 41-ATT Machine and Typewriter unit to a 3200 or 4200 Series Desk
Tools
3/16" Drill
5/16" Socket
REV
Assembly Directions
Printed In U.S.A.
93-9500974 A
Page 1 of 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Machine and Typewriter unit 41-ATT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Steelcase Machine and Typewriter unit 41-ATT

Summary of Contents for Steelcase Machine and Typewriter unit 41-ATT

  • Page 1 Steelcase, Inc. Grand Rapids, MI 49501 U.S.A. 1-888-783-3522 Attaching a 41-ATT Machine and Typewriter unit to a 3200 or 4200 Series Desk Tools 3/16” Drill 5/16” Socket Assembly Directions Printed In U.S.A. 93-9500974 A Page 1 of 6...
  • Page 2 PACKAGE CONTENTS QTY. DESCRIPTION BACK PANEL END PANEL & LEG ASSEMBLY BOTTOM PANEL PLATE (FIG. C) BOTTOM PANEL PLATE (FIG. D) MOUNTING BRACKET #10-24 HEX NUTS #10-24 X 3/8” MACHINE SCREWS 1/4 X 1” HEX HEAD SCREWS (6 REQUIRED FOR WOOD TOP) HANGER BRACKET TWIN SPEEDNUT CLIP ANGLE (NOT REQUIRED FOR WOOD TOP)
  • Page 3 BOTTOM PANEL PLATE DETERMINATION Shown below are (2) bottom panel plate templates. Place each plate on like template to determine proper usage and proceed with instructions. INSTALLATION OF BOTTOM PANEL PLATE Attach bottom panel plate to pre-drilled holes in each panel (2) #10 x 1/2”...
  • Page 4 Install mounting bracket. If you have a drawer with a flush pull insert mounting bracket. INSTALLATION OF HANGER BRACKET TO DESK Close drawer thus engaging hanger bracket to With your top drawer in an open position, center outer surface of drawer. hanger bracket over drawer front and tilt to engage rear clamp flange behind top cross brace of desk pedestal.
  • Page 5 DESK TO RETURN UNIT INSTALLATION Place end of return unit on hanger bracket and secure with (2) clip angles and (2) 1/4- 20 x 1-1/4” round head sheetmetal screws. (For wood top, omit clip angle) Drill (2) 3/ 16” thru mounting bracket and into top and secure with (2) 1/4 x 1”...
  • Page 6 BOTTOM PANEL PLATE RETURN UNIT TO DESK INSTALLATION Remove bottom drawer from your desk. Then secure bottom panel plate to desk with (2) #10 x 1/2” sheetmetal screws and (1) twin speednut. Assemble drawer back into desk. Secure bottom flange of back panel to bottom panel plate with (2) #10-24 x 3/8” machine screws and hex nuts. Assembly Directions Page 93-9500974 REV A...

Table of Contents