Steelcase 2900 Series Assembly Directions
Steelcase 2900 Series Assembly Directions

Steelcase 2900 Series Assembly Directions

Replacement of standard legs with adjustable legs for desk & table units

Advertisement

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Replacement of Standard Legs with Adjustable Legs for Desk &
Table Units 3200 & 4200 Series; also 2900 Series Tables
Tools
Assembly Directions
Section 1
3200 & 4200 Desks
3/16" Allen Wrench
Printed In U.S.A.
2900, 3200 & 4200 Tables
6" Extension
3/8" & 5/16" Sockets
Section 2
Magnetic Tip
93-9501180 A
Page 1 of 6
REV

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2900 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Steelcase 2900 Series

  • Page 1 Steelcase, Inc. Grand Rapids, MI 49501 U.S.A. 1-888-783-3522 Replacement of Standard Legs with Adjustable Legs for Desk & Table Units 3200 & 4200 Series; also 2900 Series Tables Section 1 3200 & 4200 Desks Section 2 2900, 3200 & 4200 Tables...
  • Page 2 Section 1: 3200 & 4200 Desks • NON-PEDESTAL SIDE NOTE: When removing file drawers from pedestal, the cradle assembly must be removed with the drawer at the same time. Store drawer on the front face to prevent grease damage on carpet etc. Turn desk up-side down.
  • Page 3 NOTE: Model No. 32F DAL-DBL includes adjustable legs for a double pedestal desk. (2) legs have (3) phillips head screws and (2) legs have 5/16" hex head screws. Model No. 32F DAL-SIL includes adjustable legs for a desk with a single pedestal on the left side. Each leg has different screws.
  • Page 4 Remove the front and rear legs from the end panel by removing the (4) 3/8" hex screws. Use a 3/8" socket and 6" extension. REAR Attach the adjustable rear leg to the end panel with (2) 3/8" hex screws. NOTE: The rear leg should have (3) holes to the back panel side and (2) holes to the end panel.
  • Page 5 • NON-PEDESTAL SIDE NOTE: The following Steps apply to a double pedestal as well as a single pedestal desk on the side with the pedestal. Remove the non-adjustable leg from the rear of the pedestal using a 5/16" socket and 6" extension. Align holes in adjustable leg with holes in pedestal and attach with screws in adjustable leg.
  • Page 6 • ADJUSTMENT OF LEGS Each leg extension has (4) holes spaced at 1" increments. Lift or prop up one side of desk or table. Remove the allen head screw and move extension leg to desired length. Align hole "A" in leg with desired hole in extension leg.

This manual is also suitable for:

3200 series4200 series

Table of Contents