Mounting Plate Example
FIGURE 2.
Remove the two bolts from monitor mounting bracket.
2.
Slide the node mount behind the monitor mounting bracket and replace the bolts as shown in Figure 2.
3.
Raven Interface Cable Connected
FIGURE 3.
Insert the large, rectangular node connectors on the harness cable (P/N 115-4001-089) into the correct
4.
ports of the SmarTrax node.
CAT CAN Connectors
FIGURE 4.
Before
Locate the Challenger CANbus connectors in the side panel, break the connection, and install the Raven
5.
cable.
Manual No. 016-0197-003
Installing SmarTrax with Cruizer II, Envizio Pro, or Viper Pro
After
9