Yetter STALK DEVASTATOR 5000 Series Owner's Manual page 8

For john deere all chopping / 20", 22", & 30", geringhoff all chopping / 20", 22", & 30", all calmer, all lexion/capello non-chopping

5000-071 ASSEMBLY INSTRUCTIONS

NOTE: SUPPORT THE FRONT OF THE ROW UNIT BEFORE LOOSENING ANY MOUNTING HARDWARE.

Step 1: Remove the mounting hardware & strap for each gear box where the Yetter torsion pivot assembly will

be mounted (see torsion pivot locations on pages 10 – 12 that match your devastator kit). Install the 5000-452

Lexion adaptor bracket on the bottom side of the frame using 4) 2502-813 M16 X 2 X 70 8.8 bolts, the original

flat washers & spacer bushing. Thread bolts by hand, then tighten to torque spec. (4

bolt not shown in photo)

Step 2: Place the 5000-167 torsion pivot assembly on the 5000-285 adaptor aligning all 4 holes. Thread the

2502-810 M16 X 2 X 30 bolts by hand, and then tighten to torque spec.

Step 3: Refer to page 14 for instructions on installing the 5000-292 torsion arm.