Step 4: Install the Devastator roller, spacer/bushing and bearings to the roller tube
using the ½" x 2-1/2" carriage bolts. A 3R30 roller is pictured in the diagram below.
IMPORTANT: The spacer must be installed between the roller and the bearing.
The notches of the bearing housing must face the mounting plate. The
extended race on the bearing will face away from the roller.
15
ASSEMBLY INSTRUCTIONS
NOTE: AFTER FASTENING THE MOUNTING
HARDWARE FOR THE BEARINGS, SPIN
EACH ROLLER BY HAND TO MAKE SURE
EACH ROLLER SPINS FREELY.