Resetting Fault Messages; Description Of Status And Operating Displays - SEW-Eurodrive MOVIMOT flexible MMF1 C/DSI Series Operating Instructions Manual

8.4

Resetting fault messages

Removing the source of the malfunction or performing a reset can result in an auto-
matic restart of the connected drives.
Severe or fatal injuries.
•
Acknowledge fault message by:
•
•
8.5

Description of status and operating displays

8.5.1 LED indicators EtherCAT
The following figure shows the LEDs of the EtherCAT
[1] "F-ERR" LED
[2] "F-RUN" LED
[3] "DRIVE" status LED
WARNING
Prevent unintended startup.
Switch the supply system off and on again.
Via the controller/PLC: Send "reset command".
® Plus
/SBus
DSI10A-0020-503-A-S00-000
EtherCAT / SBusPLUS
[1] [2]
®
/SBus
MAC ID
[3] [4] [5] [6]
[4] "ERR" LED
[5] "RUN" LED
[6] "L/A" LED EtherCAT
[7] "L/A" LED EtherCAT
Operating Instructions – MOVIMOT
Service
Resetting fault messages
Plus
design:
[7]
18014426770357259
® PLUS
/SBus IN
® PLUS
/SBus OUT
®
flexible
8
201